User Tools
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
labs:sp20_installation [2020/04/28 22:15] nelson [Exercise #2: Connect Board and Verify Vivado To Recognizes It] |
labs:sp20_installation [2020/05/10 00:02] (current) nelson [Final Questions] |
||
|---|---|---|---|
| Line 11: | Line 11: | ||
| [[http://ecen220wiki.groups.et.byu.net/dokuwiki/doku.php?id=springremote|The options are documented here along with installation instructions]]. This link can also be found in the lower left of the 220 wiki page and is called "Sp2020 Vivado Procedures". | [[http://ecen220wiki.groups.et.byu.net/dokuwiki/doku.php?id=springremote|The options are documented here along with installation instructions]]. This link can also be found in the lower left of the 220 wiki page and is called "Sp2020 Vivado Procedures". | ||
| + | |||
| =====Completing Labs===== | =====Completing Labs===== | ||
| Line 36: | Line 37: | ||
| Turn on the board on using the slide switch marked "Power" that is just above where the cable plugs in in the figure above. Lights should now come on on the board. | Turn on the board on using the slide switch marked "Power" that is just above where the cable plugs in in the figure above. Lights should now come on on the board. | ||
| - | If you are using Option #1 or Option #2 then do the following: | + | If you installed using Option #1 or Option #2 then do the following: |
| - Now, start up Vivado again and select "Open Hardware Manager" (center of {{ :labs:lab_1:vivadostartup1.pdf |this screen}}). | - Now, start up Vivado again and select "Open Hardware Manager" (center of {{ :labs:lab_1:vivadostartup1.pdf |this screen}}). | ||
| Line 61: | Line 62: | ||
| </color> | </color> | ||
| + | |||
| + | [[xyz]] | ||
